AEG Electrolux F55011VI dishwasher heating issue
Hello,
I have an AEG Electrolux dishwasher, model F55011VI (PNC 911935619/07).
The dishwasher was not heating properly, so I replaced the heating element (230V / 2000W) with a new compatible part.
After replacing the heater, I tested the machine outside the cabinet. During the cycle, the water temperature reached approximately 52°C, which confirmed that the new heating element is working.
However, the problem is still not fully resolved:
- The dishwasher heats correctly during the 30-minute program.
- In the AUTO program and in the 50-minute program, the water does not seem to heat properly.
- The dishes are still slightly greasy and not completely dry.
- Sometimes the dishwasher does not emit the normal beep at the end of the cycle.
- On some occasions, the cycle appears to take longer than expected or does not complete correctly.
Because the heating element is new and works in some programs, I suspect one of the following:
- Faulty or incompatible NTC temperature sensor (possibly integrated with the new heater).
- Faulty electronic control board (power module).
- Wiring or connector issue.
Could you please advise which component is most likely causing this issue?
Thank you.