u/AiIsGay2026

The Ridge Co 43 CPN pipe machinist Vice
Late 60s Wilton
Old delta bench drill press pulled out of a scrap pile.
1957 GE fridge. (Considered a tool to me)

40 dollar auction find thinking early 1940s !

Added work area to the work garage the last few days. Arbor press and drill press finally got a home and I have more flat spots to put things on !

Built this last winter for small projects in basement of my house. Spare wood from my pole barn build. Tool organizer and small vice attached as well.

New bench done and walk system started. Excited to have my arbor press, bullet vice and drill press in there permanent homes now. Exited for fab and mechanical work on the race truck now!

Had 2x6s laying around built the frame yesterday day and topped today. Will free up my 4x4 welding bench and 4x8 steel work bench by a lot. Adding wall storage soon as well. Don’t mind the mess 🤣

Looking for input. I ran this 355 all summer on 125 plate kit no issues 1/8th mile no prep. Im looking to upgrade heads cam and ditch the Hypereutectics for flat top forged with valve relief.

Currently has world product sportsman’s 72cc, and unknown cam specs.

I looking for a good set of heads used at the moment, just need advice on a nitrous cam set up to really utilize 100-200 shot of nitrous.

On to the next project electrical.

NA small tire class Wyoming no prep

Custom cowl hood junk yard score and a few hours in the shop room for a high rise single plane now !

Floor done 10ft aproach next.

My 91 drag truck. Nitrous 355/TH350, 9” ford 4.56 gear. Was a low rider in the late 90s dad picked it up cheap after the original engine blew up and built a drag truck in the early 2000s.