Help! Middle part is not sticking
I can't figure it out. I tried re-leveling twice, increased bottom exposure time, and reduced lift speed, but it's still the same. The FEP film is newish. The resin is Elegoo standard resin. I tried spacing out the models so the rafts don't touch, if that's relatable. The printer is an Anycubic Photon Mono M7 Pro. Models have a lot of holes to reduce suction and are tilted at 45 degrees. Room temperature is around 20°C and resin heater is on. Any help is appreciated.
u/Annual-Eggplant — 3 days ago