First Helmet Finished
3D printed. Not looking to get it approved, but just wanted to share since it took way longer than expected. I finished this helmet a while ago, but I wanted to post an update since I had posted unfinished versions of it before.
Originally, I wanted it to be a shock trooper design, but I ended up doing a 501st design since the paint job would've been too hard for me.
The hardest part was probably painting the mouth and stripe on the back of the helmet. Basically just the gray parts, since they were hand-painted. That's also a reason why the two gray colors are inconsistent.
Overall, I think it turned out pretty well.
You might notice a little bit of blue on the mouth as well. I only noticed it was there after the photos were taken, and I just ended up scraping it off.
The first pic is without a visor.