u/Astral-Inferno

Just wanna make sure everything is compliant and I haven't missed anything before the plasterboard is dotted on.

Ring 2.5mm, lights 1.5mm, heat alarm 3 core 1.5mm, hob 10mm, oven 4mm, cat6 for ceiling WiFi AP.

I will cap some of the cables with galvanised steel as I will be installing the kitchen.

Thanks.

Is this a problem with the oil cooler?

Garage said likely head gasket but Internet says oil cooler as gasket would mean froth inside oil fill area.

If this is gonna cos more than £400 it's kinda uneconomical to fix, such an old car.

I think if it's oil cooler I can attempt to DIY it.

How long realistically can it go like this providing I syringe out the oil from the coolant and top up the engine oil when it goes down?

BTW it showed low oil on the dash 2 weeks ago so I topped it up, kinda makes sense where it went. Not sure how long it's been going that way as I only noticed it last week. Oil piled up around the outside of the coolant tank as it's being pushed out via the sensor hole.

2009 volkswagen golf 6

Thanks.

Pics in order:

​

1. Pushed back

2. Pulled forward

3. Pushed back with ruler

4. Pulled forward with ruler (more than 1mm difference)

5. Bevelled left (almost no gap, but not yet scraping)

6. Bevelled right (big enough gap for clearance)

​

It's the 10" 40v mitre saw, brand new.

​

How do I adjust this? I tried to undo the 2 Allen bolts on the rails but they are impossible to undo, even tried with an impact.

​

Thanks.

I wanna pull them through before they build the block wall up.

Should I just drill close to the top within the cavity?

Will the top of the wall be left open so I can run them into the ceiling when it's built?

Round conduit to protect the cables going through?

Thanks.