Problems with the Kobra S1 Combo after installing the new firmware V2.7.2.1
Hello everyone, I need help!
I've been working on a large project since Tuesday, May 19th, but today I decided to take a break and update the printer's firmware, as requested in the dashboard and Slicer Next. I installed version 2.7.2.1.
What a mess!
Since the installation a few hours ago, the printer has started exhibiting errors that didn't occur before. I say this because I've been printing the same piece since Tuesday.
It's aborting print jobs, showing connection loss, "printer not ready" messages, freezing on the first filament change in multicolor printing, and emitting endless beeps when errors occur, only stopping after I turn it off directly using the power button.
Is there any way to downgrade and return to version 2.7.0.9?
I'm looking for instructions to revert the firmware and can't find them anywhere. This problem is hindering me and will prevent me from meeting the deadline. I would greatly appreciate it if someone could help me.