u/BarracudaAgreeable52

So this is more of an implicit question because I'm not actually going to use the stand itself.

My plan

I'm going to attempt to make a custom front panel for the bottom. I want to put 2 of the usb 3.1 in the angled mesh small sides as iv seen other Redditor do this mod and looks great. The main front panel (power bottom, restart bottom, led lights, audio, mic and usb c) I'm going to attempt to fit it inside the extra panel that comes with the tower 600 that is ment for the Thermaltake LCD screen. Maybe if I have room also fin an SD reader, we'll see.

I understand spending £25 - £30 on a kit just for one part which I'm not actually using for it's original purpose, seems dumb. But I think it's my best option for a clean custom build.

Main question

So with the front panel connectors being moved from the top, will the mesh panel from the stand kit fit on top of the tower 600? I will most likely have to make a cut out at the back were the wires leave the back I/o or does it have some sort of cut out. If it fits the bottom surely it should fit the top of the case?

If I do this right and take my time, I think this build will look so clean and bar the usb mod which iv seen done on the tower 300, I haven't seen anyone make a custom front panel for the bottom front led panel.

I also have e plans to make a custom housing for a 8" led screen on the angled edge inside the case but that's for a different thread.

So I got the the tower 600 and a gigabyte X870 Aorus stealth ice I have 3 120mm fans on the left, 3 120mm fans on the right radiator, 3 120mm fans on the top. 2 140mm fans on the bottom.

On the back however I wanted 2 140mm fans on the back but the bottom 140mm fan is interfering/hitting the 24pin power connector to the motherboard iv tried a 90° adapter but the case isn't allowing me to push it securely in.

At the moment I'm just got one 140mm on the back top but has anyone got a work around to allow me to have 2 140mm fans on the back?

Will I need to mod the case from to allow to use the 90° adapter. Any help would be great and anyone experiencing the same issue?

So iv seen some posts about how the rm1000x shift doesn't really fit because of the PSU bracket covering some of the connections

Was wondering if anyone has tried the HX1000i Shift as it's 20 mm longer. Does it have enough clearance to access all the connectors?

And Im getting a Corsair 360 titan AIO, will I have enough room for the tubing to go underneath the fan in-between the GPU and the rad? Will the PSU obstruct the rad or tubing?

So my Thermaltake MagFloe 420 Ultra ARGB broke after 9 months and I'm getting a full refund from Amazon.

Iv been looking at Corsair AIO and Fans. In particular Corsair icue link titan 360 RX LCD in white, but I'm not sure on the fans iv been looking at the LX fans because of the reverse fans, QX seem like the ones for the best lighting and RX seem the best for air pressure?

Can someone that has these products give us their feedback. How's the AIO on temps? And what case fans would be best for my set up? How's the wirei g work?

So I have a tower 600 stood up right and I have it setup as followed.

X3 120mm intake fans Left side

X3 120mm intake fans right side (radiator)

X2 140mm intake fans bottom (not linked)

X2 140mm exhaust fans on the back

X3 120mm exhaust fans on the top

Or I could have X2 140mm exhaust fans on top?

If I got the LX reverse fans, I would probably use the 3 RX fans from the radiator and stick them at the top or would that be a bad idea as the RX fans are make for radiators. Any advice is welcome.