u/Bobbis11

Hey y'all!

I got my hardened steel nozzles a while back. While the initial installation was fairly easy, the copper heatsink on top of one of them ended up popping off. I carefully rested it back in its place on top and tightened the screws, and it's been running fine ever since with the caveat that there is now some rattling noise when that tool head is in use.

Today it finally got to me so I attempted to put a thin sheet of foil above the copper to take up the space. However, that ended up causing an error during calibration which led me to this page in the support wiki saying I shouldn't do that.

Has anyone else dealt with this, and how did you fix it? Thanks!