u/Brudius

I started to notice parts were not as dark as they should be. If you see the keycaps I printed, the first column is the proper ones, and then the second column is the faded ones.

I switched out all of the inks since they were going to expire soon anyway. Ran a full deep clean, and then did the Eufy test print. There was almost no black on the test print. So I ran a different one that shows different percentages of color saturation.

All the colors look fine but the black. The 100% black is coming out green and the other colors should be way darker than they should be.

Not sure if it is a clogged nozzle somewhere or if it is a recent software/firmware issue.

On the left side are the good ones where the darkness is proper and has a good sheen. The right side you can see the color isn't as dark and looks a little off. Same file same settings.

Edit: using pattern texture at 0.3mm height.