Need help with how to wire my system
Here's the setup:
4 channel 1000w amp (250rms @2ohm or 150 @4ohm)
Hertz Cento C26 tweeters (in dash)
Hertz Cento Pro CPX-690 in the doors and rear
The tweeters come with a 6db/octave in line crossover.
With that wired with the tweeters, would a passive crossover still be necessary between the amp and the tweeters/door speakers? Or is that adequate enough to wire them in parallel (I think just wiring them together at the amp from what I can figure out?) from the amp to run those 2 channels at 2ohm as they are 4ohm speakers.
My other car that I have the same amp in, I started with kicker components but was very disappointed so I swapped out the door speakers to hertz and was very happy, hence going all Hertz with this setup. But the original setup retained the kicker crossover that came with the components as it's still running the kicker tweeters. But the door speakers are now 3 way, so thinking it would be a benefit to run full signal to them?