Anyone having recent issues using wallet cards to pay? I had used them before with no issue and now all of a sudden I have to insert card to validate transaction after holding AW near reader. It happens with any card I try to use.
Has anyone wondered how would it be to have say a BambuLab H2 series in terms of speed improvement?
When I first bought the Ender 3 S1 Pro did it with the upgradeability in mind just to find out later that would have been better to go all in with a full fletched printer but… budget right?. Since then I have upgraded with linear X-Y rails, Taurus V5 cooling duct, cryogrip plate and SonicPad which I have been hesitant to upgrade with Debian firmware, I even bought the BTT Eddy probe but still…
So I was curious if I set a Bambu H2D in OrcaSlicer and slice an already successful print on the Ender and see how it would compare speed wise against a Core X-Y printer. To my surprise both sliced the same print time with more or less the same print settings. Have you tried this? Is printing speed further tweaked within the printer?
I know, I know, you would get a whole lot more improvements in terms of materials, quality, reliability, size, etc. but this is just to get an idea of how would it be I’m planning on getting myself one down the road but time and budget will tell.
Going for the widest print ever. Guess there’s truly always a first time. So far so good. 👍🏼