hello I'm not sure if I did anything wrong but I wired the Rx from o4 to tx on flight board and tx from o4 to Rx on flight board, but no osd shows up. Is this a problem mission planner can fix and if yes does anyone know what parameters to change?
Hello, I recently bought a T1 ranger vtol pnp and finished building it and putting on elrs receiver so I could connect my controller. Everything went well until I received the battery. 4S 40c 3300mAh which is basically as large as the fuselage. I got it to fit in the body and was able to plug it in and do a test flight with vtol mode. I later decided to try switching from vtol to plane mode, transition was very good and the plane flew great, but when I wanted to land and transitioned back to vtol one of the wings got disconnected from the electronics (the wing was still on just not connected) which caused the motor to stop spinning and the plane to drop down. luckily no damage happened, but I'm very unsure about how to fix this issue. I have never heard about anyone having this issue. My first thought was that it's too heavy weighing about 770 gram, but it's very hard for me to find any answer since there's no one else having this issue as far as I know.
If anyone has any idea please help me, it would be much appreciated!!!
I have a radiomaster AX12. im not able to bind it to any of my elrs drones. i believe it might be something about model match, but i dont have the option in lua or elrs tab to turn it off. is anyone able to help a pilot getting in the skies again.
hello i got the 10000mah battery for my drone and its a very big battery and i was wondering how i should put it on.