u/Chief-Boyardee-

Hello,

I'm trying to fill in some walls in a part, but the extrude step fails when the width is less than 6mm. I have attached a picture of the expected result and the result I am getting when I try it with <6mm.

I am trying to do an extrude to part because there are multiple drafts in the existing geometry. I also tried achieving the same result with a sweep, but it left gaps between itself and the rest of the shell.

I imagine this has something to do with the angle where the extrude meets the part below, but I don't know how to fix it. Any help is greatly appreciated! Thanks