I'm going crazy over this notification
On all of my bambu printers, every time it's printing something with multiple colors. It gives me this notification or something similar. Usually the fix is just pressing resume and it goes back for another 10 layers then, error. But sometimes I have to remove the ams and lid and go in to unclog the nozzle. Why is it clogging this much? It's been doing this for months and I'm just so tired of it because I'm not always home or able to fix it and it sits paused for hours. Prints that should take 24 hours take up to a week. The quality of the print is usually fine and I don't even think it's clogged because of this. I use Overture filament if that means anything but it happens on other filaments as well. Please help, any tips are appreciated. It's mainly on my X2D, 0.4mm nozzle, outer wall speed: 300. Outer: 200, on PLA 1.75mm. Bambu studio slicer with nozzle temp: 220 with bed temp: 55. And the only setting for retraction I can find is reduce infill retraction which is on auto. Thanks again