The front is beautiful. The edges look almost perfectly clean. But if you look at the top there are some markings on the back.
Will this prevent it from getting a good grade? I'd love to see it in a slab
Wondering if this is worth grading. It'll be my first submission. I know the back is slighty off center, centered a little low. Confirmed this with a centering tool, otherwise I wouldn't have seen it. I'm also worried about the back right bottom corner as there seems to be a rough spot theree
Neptune 4 Pro - Y belt starting to strip. I was able to pull a slim piece of it after noticing a lot of dust around the front of the printer.
Printer has about 1300 hours on it. Should the belt last longer than this? Or is this about right? Did I have it too tight?
Any help is appreciated so I know what to expect moving forward, and if I need to adjust what I'm doing.