u/DasAutoPoosie

Really happy with the way it turned out. Had some custom metal logos made from 4customize. If anyone has used similar metal stickers for logos, do you have any tips for dealing with the sticker leaving some adhesive on the dial. I try and cut it as small as possible but once it gets on the dial it’s hard to remove. Thank you, and thanks to this community for all the help and tips.

Right out of the box. Date changes over at 12 but nothing on the quickset. Anything I can do?

I’m building a sea master inspired mod for my new brother in law as a wedding gift. He’s not much of a watch guy but does a lot of water sports and sailing so I think he will love it.

First time trying to source a 31mm dial and I’m wondering if anyone has suggestions based on experience with purchasing and quality. Case is sea master inspired with the blue bezel so looking for something similar style to the dial pictured. I’m doing my own logo as well. Will be NH35, do you need a different spacer or anything for use with larger dial sizes?

I appreciate all the help and advice and becoming more addicted everyday. Thank you!

Bit over two years self taught. irons have been great lately but with or without a tee I can’t stop topping my woods, clip is 5W. Last year this was my go to fairway finder. Now I have zero confidence. Even topping my driver lately too. Worst ones are where the ball is literally carrying 30 yards cause of the miss hit. I try to hit my woods for the most part like my iron swing.

Seems like when I try to adjust I start excavating. Maybe someone here can see something I can’t or offer advice.

Can’t get crown to screw down as it seems like it’s binding with the whole movement. If I take the white spacer that came with the case out and the movement has room to move around a little bit it threads down fine but then the whole dial is off centre. NH70 with the adapter. Movement won’t click into case it’s just kind of loose with the white spacer but when I screw the case back on everything seems fine except the crown wants to cross thread.

Having an issue getting the proper stem length with this build. The first one I cut too short but I thought I measured it perfectly using a calliper to measure from the end of the case crown threads to the inner edge of the crown.

I did it again and got the same measurement but left it longer on purpose. Was almost good but just needed to trim a little bit as it just a bit to long to be able to catch the threads on the case.

I trimmed a tiny bit off until the crown was able to thread into the case but the movement stays stuck in the time set setting until the crown is almost half way screwed down. When I unscrew it it’s in winding position but when I pull it out to set time then push back in there’s not enough room and the hands are moving while I’m screwing the crown down?

I made the smallest adjustments I could to the stem and am cleaning the threads after each cut.

I must be doing something wrong?

Nh70 got the movement spacer for the 28.5mm dial, when I put in the case it moves around side to side a lot. Cannot use the white plastic spacer thing that came with the case, no way it will fit. Not sure what to do.