u/Ding42

Trying to print some flying bases and the auto-generated supports don't feel good, either straight up or at 45deg.

The horizontal feels a better, but is going to have so many attachment points all up and down the stand that it might impact the finished model... I'm printing in transparent resin, so was hoping to avoid too much in the way of sanding

Complete newbie - any advice on any of this before I go full "trial and error" mode would be greatly appreciated!

Did not take the proper time to clean/filter the ipa properly and rushed into a cleaning cycle.

Gooey resin clumps all over the print and plate. Managed to clean most of it - but the back of the actual build plate is still covered.

No loose debris, but not clean by any stretch. Do you think this will be ok, or have a wrecked it?