Thrift store prusa
Hey everyone I am super excited about getting my first printer. I found a prusa mk3 with some upgrades in a thrift store for $100. It has just over 8400 hours on it but seems to run great. I think it needs a new build plate though because I've been having really weird bed adhesion issues and the bed itself is very scratched and scuffed, because of that the first layer is only as good as I could get it but it needs some work for sure. I managed to print a calibration cube with some minor defects (picture attached). I could use some help identifying all the mods that have been done to it and would appreciate any tips and tricks and advice to help out. I've cleaned the and lubed the rails and cleaned the build plate and nozzle so far I'm just not sure where to go from here.