u/Ecstatic_Ease_5007

Hi I’m a pinball technician and need some special connectors printed. I’ve used jlc3dp and they worked great for a couple weeks but started to warp. They arent really exposed to any heat just molex pins pressing against a pcp board which caused the warping i think. I had a friend print me a set and they were hard as rock so no warping but where way too tight to get onto the pcp with the pins installed. So id need them ridged enough to not warp from the pin pressure but flexable enough to get onto the board without cracking apart. There are 10 connectors total and would like 5 of each. They aren’t very large. Here is a image of one of the jlc3dp ones that has warped

Not sure on budget as I don’t know much about resin printing. I’m assuming around $50ish but don’t know if I’m wildly off