u/ElectricalTwist4083

I have a water line to run in a die made of 6061. It’s at a 40 degree angle and in doing it on a gun drill. To get a flat surface to set my GD up against in need to spot face a counterbore about 4.5” deep at 1.5” dia. The problem is that my aux spindle that I use to do things like spot face and thread mill is only a few inches away from the main drill head and it’s getting in the way of reaching the work piece. To facilitate this operation I needed a tool setup about 18.5” long. As of right now I have a 1” flat endmill I’m going to use but with a stick out that long I have no idea what type of speed and feed to set for a functional helocoidial program. I know it will need to be slower than my normal 1200rpm and 30ipm but any help would be great.

I know she is able to be freed in Chrono cross but Schala definitely had to survive and we knew that because Nadia had the pendant. Doubtful that it would be a recovered relic from under the sea by 1000, hereditary ownership is the only viable solution.

So I think there could be good potential for a Magus/Janus based spin off. He appeared in 600ad and had a whole ass life. And organized the Mystics, taught them to harness magic, built Medina, located the palace of the elemental weapons, and led an entire campaign against the humans(for ACTUAL reasons as yet unknown). All while secretly having a campaign of his own against Lavos for his whole life. That’s a hell if a story, and we could get Cyrus missions and tons of lore. What are your thoughts?