Hello everyone I’m just a consumer who has little to no knowledge on the plant in growing and figuring out that buds come from females I had a friend give me a few seed and no mention of there autos or anything just hey it’s weed so I’m trying to figure out if I have a dude or not cause I hear they don’t produce buds but are good for hemp
I have a rig given to me by a friend and I have almost no need for since I game on a steam deck but it’s has what’s listed below and I would like to make a passive income nothing crazy maybe gas money at the end of the month or buy a ¢0.50 taco a Jack in the box. Is this still viable or should I scrap it instead ??
AMD Ryzen 3 3200g
RX570 4gb
16 gb of RAM
1tb HDD
So I have a BB19 And it’s using all gen 3 Glock 19 parts my mag fits snugly not to loose but when it goes and loads another round I feel the mag jumping or moving in the mag well but doesn’t do it when I cock it back and manually unload the rounds or is the mag release for this is a gen 4 cause I’m using a gen 3 mag release
Hello I’m trying to figure out why my G19 isn’t extracting correctly. What I mean is it pushes back but shell doesn’t fully dislodge itself from the chamber getting stuck in the middle. I did have problems with light primer strikes and took care of that with polishing some parts
Just wanted to post a pic of my print thank you 300blk setting on ECC1 using sunlu PA6-CF
This is not my image but I grabbed it off Google to convey what I’m trying to describe the other 3 are my car . I had swapped my front bumper on a 2020 SXT to a SRT front bumper and had removed the brake air ducts front the front bumper of my sxt and curious if the can be installed on the new front bumper or do I have to get the ones the R/T and SRT have
Just an odd question my print was a 14hr print I checked it on its last 30 min and everything looked fine came back from the store and saw this messed up thing