Atrius 3 position HELP WANTED
I bought said trigger and installed it in my ar9 with a Mil-Spec trigger. I have no binding problems whatsoever but my problem is worse. I’m getting out of battery detonation. When dry firing and rapidly pulling the charging handle to test it the firing pin is engaged with the bolt around half an inch away from engaging the feeding tube/barrel. When testing it in frt mode I got the first shot then the second would blow your eardrums and I was shooting subsonic suppressed. I’ll be wearing ear protection from now on in further testing lol. I stopped shooting the gun until I figure out a solution. Additionally, while simulating lever movement with just the lower itself I found out while pulling the trigger and letting the lever come towards the hammer which is the follow up shot, the pressure from pulling the trigger forces the lever to slam forward. Even when in the safe position in frt mode where the lever is back I can pull the trigger really hard and sometimes it moves the lever all the way forward. The only video I have seen that talks about this is on YouTube and his solution was the shave off a very very small amount of the bottom of the cam on the lever or shave off a small amount on the trigger where it contacts the the cam on the lever. I’m not sure if that will work but I’d like to know if anyone has a solution. PLS HELP THANK YOU!!