u/Empty-Code-6743

Whats your opinion about this housing? Very corroded? Can still use it?

Since I didn't like the common supports that go in the original position of the coils or on the strut, I decided to design my own to get them on the engine itself. All this while maintaining the entire original intake system, oil filter pedestal, infill, ... of the FC.

I would like to hear opinions, objective data, and so on. They are very tight, especially at the back, and I don't know how well this design works for coil cooling.

I hear you!

FC Turbo 2 90', I'm going to install a completely new engine (streetport) except for one rotor (this one from the photo) and the eccentric shaft.

It had lot of carbon build up and while cleanning it i noticed this stripes.

Any advice is welcome.