I have had trouble where the system ejects PLA CF after a while if printing, or simply replaces it with an available PLA through the Canvas. Now i see that Elegoo doesn't state it supported using the Canvas
With the Canvas installed and on the latest software, is anybody else experiencing the issue that a levelling calibration must be done before each print? Even calibrating and printing for a few minutes, stopping the print, removing the parts without removing the plate, the Z-offset is way out and scrapes the plate. Regardless of filament or print plate type. It has already damaged 2x print plates.
After years of printing, the fun starts again by designing and printing new parts for printers. I took parts from multiple uploads, modified and designed new. This is the end result, including the use of my old riser to not waste
I PLA CF from Elegoo as it prints beautifully. Using a 0.6 tip is preferred and last week printed around 600g for a new hood using Canvas. Yesterday the Canvas arrived and I installed it and since then, endless issues with PLA CF. Print keeps pausing with it battling with the CF. I have thrown away several prints in CF, but no similar issues with normal PLA. Anyone else experiencing this issue with the Canvas and CF filament?
I had my printer on an old firmware V1.1.29 until a few days ago and moved up to V xx.44 and now to xx.46 in anticipationof the canvas deliverynext week. On both i experience the light turning off problem, but even worse, levelling calibration is terrible. All screws are tight and bed isn't loose, but immediately after a calibration the print has clear points where the bed drops lower. I have been using this printer since September without any issues like this. Even a 20 min calibration doesn't resolve the problem. Even a calibration immediately before the print makes no difference. Tried several print plates, all cleaned with soap and water. Replaced the hotend with a 0.6 as test and no difference. Tried several filaments, all the same result.