Previous post is posted below. I found a sly comment saying the tilt trim may have issues with bleed type things if the relief valve is open just a little bit. The valve was just a quarter turn out and heavily affected the mechanism. I do have a leak at the dust seal at the end of the ram, but it’s better than replacing the internal seals!
https://www.reddit.com/r/boating/s/qgBY6glKVB (link to previous post)
I replaced the window mechanism on my rear drivers door in my 100 LC. When I roll the window up with the auto function, it automatically rolls down halfway. I have tried “retraining” the motor by holding the switch at the top and bottom for 5 seconds each. I have not found a sure fire way to fix this without consulting a shop. Does anyone know what I can do to fix this?
I want to upgrade my lighting on my 100 LC. My current options are grill lights, bush lights (hood mount), and probably Ben3D builds fog lights. Has anyone done similar upgrades? I posted links below for what I’m talking about.
https://www.akioverland.com/collections/toyota-lc100/products/lc100-grille-bracket
https://www.akioverland.com/collections/toyota-lc100/products/toyota-lc100-ditch-light-bracket
https://forum.ih8mud.com/threads/ben3dbuild.1171700/page-100#post-13562268