Had the chance to use some cool tools at uni. So whipped up a new plate holder. Will throw files up on 3D Cults this evening.
Made from 2.8mm SS. Super solid. Two piece design because pieces can't go in as one. Have to be split and meet in the "mouth" of the car.
Took me a few prototypes and many edits. So I figure it could save some time for someone.
The plate sits vertically, and as far left so as not to block the radiator ducting.
FYI, this is designed to fit both Victorian(Aus) and NZ plates. Modification should be made to fit other sizes/countries.
Uses 3 M12 bolts from the tow hook. Two M10 bolts to mate the pieces. And 2x nuts/bolts to hold the plate on.
Will edit this post with link to 3D files when I'm home.
Plate is digitally edited for obvious reasons.