Can't figure out if slicer or bed issue - CC1
I'm trying to print this articulated ATAT model. I have about 1000 print hours on my CC1 and haven't come across an issue like this. I'm assuming it's a slicer issue, and I'm using Elegooslicer.
At first I was using side A of the Original Build plate. All the pieces on the left hand side that use a brim did not stick to the plate. Also one or two of the pieces next to them. Everything else printed fine. I only noticed when print was halfway done that the left side was a spaghetti monster. I stopped the print cause I didn't trust the misprints to not interfere with everything else.
Since adherence was an issue, I switched to side B. But it was even worse on side B. Luckily I was there to stop it before it got past the issues on the left side. So, long story short, these are my current settings after tinkering with it some more. I don't normally print that close to the left side of the plate so I'm trying to figure out if it's my settings in the slicer or if there's something wrong with the machine. I'm entirely certain it's user error.
Any advice can help. The last thing I did was raise my plate temp and slow down the speeds of the first few layers. Last pic is current photo of first layer in progress. It just looks wrong to me, but I can't pinpoint it.
Edit: After running the test, I replaced the nozzle and releveled and it works perfectly. Thanks everyone for responding.