u/Far-Cartographer-368

Pretty self-explanatory the bottom left corner of my Q2 bed cannot be made level. I have manually twisted the bar on the left that the build plate lifts and lowers on, but then when going to the next step in the manual leveling the plate goes back to the same as it was before. To give an idea when I get the Top left, top right, and bottom right leveled so they provide slight friction on a piece of paper the bottom left corner has about 1/4 inch between the build plate and the nozzle. Loosening the nut on the screw below the left bottom corner does not lift it high enough, because after about 1-2 full turns the nut is able to be removed by hand and the corner is still about 1/4 inch away from the nozzle.

As stated in title the extruder on my Q2 will not allow filament through. It is not clogged nor are there pieces of filament on the gears it is a brand new extruder that came directly from Qidi. I placed my old extruder back on and same issue. I say old, but it is only 2 months old. Had to replace because fixing a clog I dropped the gear and the metal post got lost. Anyway can anyone please help before I just sit this thing ablaze

As stated in title the extruder on my Q2 will not allow filament through. It is not clogged nor are there pieces of filament on the gears it is a brand new extruder that came directly from Qidi. I placed my old extruder back on and same issue. I say old, but it is only 2 months old. Had to replace because fixing a clog I dropped the gear and the metal post got lost. Anyway can anyone please help before I just sit this thing ablaze