u/Far_Ad_6980

1. ⁠⁠Dealer name: The One Watches
2. ⁠⁠Factory name: F1F
3. ⁠⁠Model name (& version number): Tank Louis 25.5mm Brown RG/LE White Dial Quartz
4. ⁠⁠Price Paid: $228 (+Shipping) 
5. ⁠⁠Index alignment: Looks good to me, 9 and 10 might be a hair low? I cant tell if the roman numerals are sitting centred in the dial. I feel the XI sits slightly closer to the top than the I?
6. ⁠⁠Dial Printing: looks fine, the E in MADE is not printed as clearly as other models however it's so small i doubt it would bother me.
7. ⁠⁠Date Wheel alignment/printing: n/a
8. ⁠⁠Hand Alignment: looks good in video
9. ⁠⁠Solid End Links (SELs): n/a
10. Timegraph numbers : n/a Quartz
11. Anything else: I wanted to see if i'm missing anything obvious (wouldn't be the first time) I also want to make sure the dial isn't tilted. The screws on each side of the case look like they have potentially been damaged? As always- any help is much appreciated!

Dealer name - Theonewatches (Steve)

Factory name - VSF

Model name - GMT Master II 126710 Batgirl 40mm Jub SS/SS Black Dial DD3285

Price Asking: $578

Index alignment - Is 9 o'clock baton tilted up on the right?  6 o’clock marker slightly off center to left? I've attached two different QC ruler photos with one looking better than other so It may just be tilt.

Date Wheel alignment – looks like 2nd number is slightly lower than 1st? Cyclops damage at bottom right corner?

Bezel - Looks good

Solid End Links (SEL) - No visible gap

Hand alignment - Good?

Dial Printing: Crisp

Timegrapher numbers: +1s/d 285 at 59 deg 0.0ms err. Ok and within range

Anything else you see – After the first watch was a RL due to damage (which I totally missed so thank you reddit) I'm not sure about the cyclops or alignment on this.

Dealer name - Theonewatches (Steve)

Factory name - VSF

Model name - GMT Master II 126710 Batgirl 40mm Jub SS/SS Black Dial DD3285

Price Asking: $578

Index alignment - Is 6 o'clock and 12 o'clock marker sitting left on the dial?I've attached two index ruler photos with one sitting in the centre of the markers, but slightly off the centre of the watch (central pin of hands) and the other sitting flush in the centre, which shows 6 and 12 o'clock marker off centre to left.

Date Wheel alignment - looks good

Bezel - Looks good to my untrained eye.

Solid End Links (SEL) - No visible gap

Hand alignment - Good?

Dial Printing: Officially looks a bit crooked? (OffiCiALLY Certified )

Timegrapher numbers: +3s/d 269 at 59 deg 0.0ms err. Ok? Is 59 deg ok for this mvmt?

Anything else you see - Potential scratch on in 12 on bezel