u/Firefighter-Volunter

So far : The timing belt, cam and crank seals, Water pump, thermostat, egr delete, tons of rust removal, redid all fuel hardlines and about to replace pump, and fixed the mirrors, have all been completed.

Last thing is to tackle the ignition tune up, slap the bed back on, resplice a wire harness, and some misc paint spill cleanup and ill be off to the races.

I've also 3d printed my own fuel line holders since the last one broke during removal, and 3d printed my own cam and crank seal install tools.

Currently rust treating the bed and while I wait redoing some fuel lines that were rusted while I have access to them. Currently 1 fuel line of 3 done. Using harbor freight tools and they are doing well

Never wanna worry about rust again. First import and just removed the bed. Time for walnut blasting and rustoleom rust neutralizer