u/Flakman23

My side art was printed out on glossy paper from a huge inkjet printer. It looks absolutely incredible just a little glossy.

My question is what can I spray over top of it to protect the ink and seal it. I'm afraid if I spray something on it the ink will run. I went to Walmart and Menards this evening and found various versions of Krylon that is clear, some glossy, some matte.

With so many options I just want to make for sure I'm getting the correct product unless there's something different than just the Krylon that I found.

I thought about polyacrylic I saw that over at Lowe's but I'm not too familiar with that and it could make the ink run.

I am gathering parts for my Vpin and using CSD PinOne as my board. I bought 8 of the Siemens contactors with the surge module installed, but had a question. Do I need the solenoid life extendes for these? Can they be used for flippers, even though you hold the flipper at times? Or should I use the 12volt solenoids for the flippers with life extenders on them?

Thanks