Heygears Reflex RS Turbo PAS10 print failures
Hello everyone. I have a Heygears Reflex RS Turbo with Pulsing Module and have been having print errors with PAS10. (First prints were PAP10 with zero issues but with generated supports)
I am printing Kali from Aradia Miniatures (pre supported) and the model seems to be falling off of the supports. Also the supports seem softer than usual compared to my earlier prints.
I have stirred the resin in the vat for a few minutes, ran the vat cleaning after every failure and now I'm reslicing Kali again for a third try. (Failed three times now)
I thought Heygears resin and profiles were almost worry free? My next idea was to increase the exposure times, but I would have to switch to a manual configuration rather curated print profiles from Heygears.
Is this the time to switch to custom settings? I got this printer because I was under the impression it was kinda like what Bambulabs is to FDM printing.
Or is there anything else I could do?
Thank you for reading