u/Fun_Penalty7755

I recently purchased an Airtac adapter and found that at 90 psi it cycles extremely sluggish sometimes not even returning to battery. When testing with green gas magazines or an Hpa tapped green gas magazine at the same pressure the gun works flawlessly.

I seemed to “fix” the issue by increasing the psi to 110 and then 120 but it still is a bit lackluster compared to the green gas magazines.
I know this high pressure increase stress on the internals so I’m not planning on increasing the pressure.

Is their a fix to this where I can reach the same performance on green gas magazines with a low pressure of 90-100 psi on the Airtac adapter or due to the Airtac adapters design am I forced to use it at a higher pressure than I want?

I am looking to ship SAIGA parts to the U.S should I use sureship or is standard airmail or UPS fine since I’m not shipping guns?

I am looking to ship SAIGA parts to the U.S should I use sureship or is standard airmail or UPS fine since I’m not shipping guns?

Are there any u.s based retailers or online retailers where I can get the following C&C tac parts for my SAIGA without spending $100 in shipping or if I want them am I just going to have to bite the bullet and spend the $200 for it.

I have a saiga and my understanding is that the inner barrels can be twisted to create more or less of a spread. I’m finding the stock spread to be manageable at my outdoor field but would like a tighter spread to be more accurate at range.

How do I go about aligning the inner barrels for a tighter spread?

Are there any videos I can watch that will show me how to do it?