u/GazelleOpposite1436

A while back, I had what I thought was a couple dead pixels. I tried what I read online, which was pressing that area of the screen with a pencil eraser. Turns out my poor eyesight screwed me up. It was an ant that I successfully smooshed in its place. It's bugging the shit out of me.

​

Any advice to get it out? It is an Asus VG248QG.

When I ordered this LVP, I wasn't sure what the height difference would be, and I was hoping to get it very close to the existing wood floor. Ended up with a ~3mm difference after the install, and ordered the transition for that 3mm difference.

​

When I installed the LVP, I left a 5/16" gap along edges per instructions. However, the transition instructions call for 1" gap for the slim trim dowel installation method, which is the only method for which it provides instructions.

​

It also has a metal trough that looks like you would screw down and the trim would pop into place.

​

I don't seem to have room for either method, while leaving enough room for expansion, so I'm looking for some advice.

​

How would you approach this?