u/GlitteringPop5562

Hello all, complete beginner/newbie here.

I'm looking to build a Mini Moonboard without the LED and I wanted to basically add a tnut for spray equidistant at a diagonal offset to the moonboard holds.

I tried to do a rough mockup using a sketchup I found from a youtuber (shoutout to Jake Krebs!), where the dashed lines intersect would be for spray, and where the solid lines intersect would be for the moonboard holds.

I also found another post from this subreddit that also did this (included in screenshot).

Questions:

1. I'm an absolute newbie but is there anything I should be aware of when doing this? I literally just took the midpoint, and plan to drill it in (at least in the spots that wouldn't be impeded by a stud from the back).

2. I noticed this other youtuber that followed Jake Krebs tutorial installed joist hangers on both ends of the studs, whereas it looked like Jake only fastened his with screws at the top and then attached it to the kickboard with joist hangers. Should I be adding joist hangers to both ends?

Also any help would be appreciated. Bonus point for if anyone followed Jake Krebs tutorial.

Thank you!

Newbie here, I noticed my basement sink p-trap was leaking and upon further inspection I found gunk/residue coming out from the glued-in side, and also the nut is cracked on the left. The leak does appear to be coming from the glued-in side as it is damp/wet.

What are my options on how to repair this? I did some research and it seems like I need to cut away the p-trap and install a new one in. The thing is because it's attached to a bunch of existing pipes/fitting, I'm not really sure where to even get started.

Where would I cut on both sides? Especially the sink side, if I cut it at the opening, would I have enough pipe for my new p-trap?

Not really even sure if what i'm saying is making sense, any help would be appreciated!

https://imgur.com/4mKQUyz

https://imgur.com/hPXrWcJ

What day did you board the Soon train on Steam?