Does Netbird have the ability to not activate the tunnel when at home or other trusted locations? For example, with Wireguard, I have it configured today to automatically turn the tunnel on for all traffic when I leave my trusted WiFi networks. Soon as my home disconnects from any wifi or connects to any WiFi that's not my home SSIDs, it turns on. Turns off when I'm at home.
Hey all, using the search bar in the DDG browser, or the DDG Search tool, I'm finding it times out and stalls, sometimes doesn't load at all. Happens across multiple devices on the network, but it's not consistent. Has anyone else see this happen before? any idea where to look?
Finally got all the pieces I need to do a Gen MTTM to WD1863 switch. Only thing I'm concerned about right now is getting the pushers down. Best option I think I have is a low-powered Dremmel with a sanding attachment. Mark 1mm on the pusher, sand it down, test fit.
Only other option I have is a pair of diag cutters, but my small ones are cheap, and my nice ones are huge, so I don't think I'd get a good cut if I tried.
UPDATE #1: OK, word of wisdom that I needed? Crown pulled out to the first position and then push the release. I almost drilled a bigger hole to accomdate this.
UPDATE #2: Crystal removal is proving to be the most challenging. Right now I'm using a box cutter with a fresh blade to cut away the case to get under the crystal so I can pry it off. Challenge is, it seems I'm just scraping the crystal and not getting under it entirely.
UPDATE #3: Got the crystal off. By far, most stressful and challenging. I essentially used the box cutter to chip away at the case to get to the edge/bottom of the crystal, then used the blade to get under the crystal and start to separate the glue/adhesive. After many minutes of moving around, finally was able to pop the crystal off. Next up, filing the pushers. Plan is to use a Dremmel and sand bit to remove a mm of the pushers. I'm going to mark the pusher with a sharpie so I know how much to remove.
Does anyone have a video on how to file the pushers to work with a gen movement?
Also, anyone know how long the crown stem needs to be with the WD1863 crown?
I'm running into issues with getting a black dial V2 WD1863 on Amazon. Ordered one last week with a 1 delivery, and it never shipped. Was told by Amazon to cancel and re-order. Did that, and it's still not shipping. I'm planing on using this to do a MoonSwitch, so I'm not using the movement/dial.
My question: It's hard to tell on Amazon, but is the case/bracelet/etc the same between the White and Black dial V2? Or are there other differences? Is there another WD1863 on the Amazon Store I could use that might fulfill?
Thanks in advance!
I ordered the WD1863 V2 from Amazon and it shows a delivery for next day, but it’s not even shipping. Anyone know if there’s issues from the WD store on Amazon?