u/Inevitable-Debt-1606

Kinda new to 3d printing, had my AD5X for a couple months now. It prints single color perfect. I printed the little tug board in 4 colors a few days after I got it and it did fine. Now it refuses to do multi colors. I have done the changing of the cutter location and waste extruder locations. And it get the error shown every time at the same location. Tried this about 4-5 times now in this file. Other parts do similar and fail at the same point upon cleaning, adjusting and restarting. I always run the 26 point leveling before each print. Firmware is up to date and my orca is up to date. Using PLA and default settings. Any ideas?