u/InfiniteAssignment95

I posted a while ago trying to find a set of seats that sit lower in my new edge. For anyone also looking for something similar, I purchased a corbeau Evo X seat and corbeau seat bracket. When I installed it per corbeaus instructions, I still sat at about the same height as the factory power seat and a little to close to the steering wheel, so I decided to ditch the supplied sliders and build my own fixed rails. Using 1/2”x1” square steel tubing in place of the sliders, I’ve got the seating position about 2” lower than factory. Just thought I’d share this incase anyone else hates the stock seating position, I can also now wear a helmet and not bash it off the roof in the event of a side impact.

Anyone have any diagnosing experience with a Texas speed cal? Mine had been in the car for 20+ years and finally died. It’s just a circuit board on the inside so maybe an electronics sub would have a better idea on where to start. My tune is a custom file from a tuner who no longer works on these cars so I’d rather not go the retune route.