u/Intelligent_Aide_592

I have been messing with my profiles for days at this point trying to get my petg to a usable point. I started with cura slicer and was having issues with slight layer shifts. I switched to orca and am not having that issue but am dealing with a new.

I have attached a picture
running a Ender 3 s1 pro with a sonic pad
I also upgraded to a Taurus v5 with 2 5015 hoping that was the issue, it was not (I could be tuning wrong)

Creality Fillament
I printed temp tower which 250 looked best
75 bed temp
using the default speeds with orcas slicer for sonic pad (200ms in and outer, 7000accel, 300ms velocity, 4mms cornering)
I have messed with fan speeds but no avail..
Have done resonant test, e step tune, PLEASE HELP