u/Justifiably_Confused

So I did an oops clearing out a clog and ripped the hall cable thing - replaced it all good but now when I print I have issues I didn’t before.

It starts the print, goes through all the bed levelling fine gets to the print calibration line it pretends to print it - but is too high off the bed and suddenly the Extrusion Motor has an overload, if I click “all fixed do your thing” without doing anything else it starts printing the item as if it had already printed the calibration line.

I’ve googled up a storm trying to find out whats wrong but no luck can anyone provide advice?

Before I realised I could just click all fixed and it start going I was checking the ams for snags on the roll and there wasn’t ever any found.