u/Known-Influence-1730

Parts geek has so many manufacturers of wheel hub assemblies it's hard to know which one is with putting on my GX. I would like to not have to replace them again, so I don't mind spending the money. Advice on this would be appreciated.

Just had the bushings, minus the steering rack done and some new lower rear control arms by iron man installed. The mechanic was going to do my steering bushings too but informed me my rack is leaking and needs to be replaced soonish, so I'll do the rest of the bushings then. But after 220,000 miles I gotta think my wheel bearings need some attention, at least a good cleaning and repacking. Anymore have experience in this endeavor? I'll do it myself if it's not a complete bastard.

So I'm having my bushings all replaced along with some new LCAs, for 1400 bucks. Does this sound like a good deal?

The same shop that did my lift and replaced my UCAs is offering to do all my bushings, minus the UCAS, install some new HD Iron Man rear adjustable lower control arms, with all the labor for 2000 Canadian, wich comes out to about 1400 USD. I tow my camper quite a bit in the summer so these 17 year old bushings are in need of being swapped.