u/KonkeBonk

Hi, I'm wondering how I can create a rectangular pattern where the patterns are tangent to a wall. See the attached picture, please. There you can see an ellipse with with an offset wall. I'd like to get the "pillar's" top line to tangent attach correctly to the offset wall. Is this possible without manually have to make them tangent (which I know how to do)? I will make the number of patterned pillars parametric which means it might change later on, which then could mean I'd have to manually fix them. Thanks in advance, and I hope you understand my question.

Hi, I'm wondering if you have any tips on creating legs for a table lamp in a good way. I'd like them to be cylindrical with the top part having a bit higher diameter than the bottom part. I'd also like to make the legs flat to the ground, and have slick contact with the curved armature.

This is probably possible to make in a lot of different way. I'd like it to be parametric if possible, and as clean as possible. Any ideas? Thanks in advance!

Hey guys, what could be causing these strange lines? I've tested with two different filaments and colors, as well as a textured and a smooth plate. The model has printed fine before. Bambu Lab A1, PLA.