Mid layers warp/look messy, Sovol SV06
Hi,
recently I tried to 3D print a brain hat from Thingieverse, (https://www.thingiverse.com/thing:1811251) and the outcome is not looking too good. Before this I've had no issues with it, but since I moved to a new apartment it started doing this. First and last layers seem ok, but everything in the middle is horrible. What could cause this? I noticed that it had the red LED burning on when I went to check it mid-print. Think it has something to do with the Z-layer sensor or something like that?
Did the usual manual calibrations after I used it the first time after moving, but this is a completely new problem to me. Anyone got ideas what might cause this?
0.15mm layer
30% infill / lines (usually use gyroid, this time was different)
Print speed 60mm/s, worked fine earlier