u/LogicGam3z

Picked up a 365X slide with the new Shiv and haven’t shot it yet. When the slide is locked back, there’s initially a small gap between the Shiv and the optic/mount area. However, with the normal barrel play that exists even with the slide locked, I can wiggle the barrel upward enough that it fully makes contact.

I remember seeing a thread where someone cracked a Shiv in almost this exact spot on a non-Flux setup, so I’m wondering if I should hold off on shooting it as-is or if I should carefully dremel a little clearance into the contact point first.

Anyone else run into this?