u/LuckyJungle

Vehicle is a 2000 Land Cruiser (US-Model). Trying to figure out what should be here. Any help is appreciated.

I bought a Trek 850 and want to add a 35mm stem with 6-degree rise, Surly Sunset bars, and a quill stem adapter.

I noticed one of the cables goes through the current stem. What would be my workaround?

Would I gain a more upright position with less reach?

Edit: Arent you all supposed to say the only workaround is v-brakes and a 1x drivetrain ;)?

Original Post Link: https://www.reddit.com/r/woodworking/s/lmdO0E9oHT

I was able to get the table almost flat. Grizzly is still sending a replacement. I was able to rip a thin strip after dialing everything in.

Over a 7 3/4” long piece, I'm 11/1000 of an inch off in thickness from one side to the other. Not bad at all.

I bought a new G0513Z bandsaw from Grizzly. I can’t get the blade 90 degrees to the table on both sides. I checked the table, and it’s not flat on one side. I put the pin in as far as I could, and it’s still way out.

Is there something else I can adjust, or do I need a new table from Grizzly?

Thanks, all.

UPDATE: Grizzly support is sending a new table. They believe mine is too far out of spec. They will be inspecting the replacement before sending it out.

I scored this 3 HP Delta Unisaw for $575. Does anyone have recommendations on how to set up dust collection? I'd prefer not to drill into the cabinet.