right now i have a stuck eotech exps 3-2 stuck to my pic rail and am thinking of switching to a riser mounted 512 model eotech for nvg compatibility and back up use of irons so that the setup is super reliable. my question being is there a pic rail riser that would allow a eotech 512 model to ride just above the riser without looking stupid?
I bought this plate carrier from a reputable vendor who sold it to me saying it was a ‘prototype’ but he wasn’t able to sell it to anyone bc no market or it may have been too heavy of a set? I’m unsure. The right shoulder ballistic insert had that writing on it, cut into slightly to see if it was real kevlar. The nape, shoulders, and neck guards are all detachable. The stitching is not good, some portions of the molle is semi-unusable due to the bad stitching. Cumber-band is also bullet resistant with 3a kevlar . After shoving my hand into both the front section and rear section of the plate carrier the 3a kevlar runs from covering the entire front area and back area (chest) and (back) to shoulder. All in all I snagged it for 500 dollars. Came with carry case from midwest armor and strategic solutions but when I checked Midwest armor and strategic solutions, I couldn’t find anything. Last picture is the cumber-band and the front neck guard that affixes to the rear nape guard with Velcro.