Do not buy this machine!
I have had this machine for 6 weeks. It work ok for 3 weeks and then the errors started. Toolhead errors. At first I just ignored them turning the machine on and off and resuming. Until the machine stopped printing at all. I followed step and decided it is probably just a cable contacted support and got it replaced. It did not fix the issue. Now every toolhead is erroring on every one except the original. It takes a full 24 hours to get tech support via email to get back to me. So I went on FB and someone suggested the belt maybe too tight. So I went to go adjust the belt and the toolhead switch was bulging on one side. So I thought we really have a problem. So I sent that picture over to them. They sent back that they are going to have me replace every board in the machine. They did not address the bulging part. I assume because it is not replaceable. So now I have to wait another 24 hours to get a response. I have asked for a machine replacement. i went for a completely assembled machine. Not something I have to complete disassemble and reassemble. I feel like I waisted $900. Here the thing I get it I must have gotten a lemon. Ok. The thing, that get me is that support feel like an AI bot. I have Gavin but the bot apparently cannot see that they just sent me a part and got my receipt because they are asking for all the info again. So either I am talking to different people or it a bot. Anyway let this be a caution tale. You may get a perfectly good machine or you may get a lemon. In my 20 years of 3D printing . Bambu and Prusa would never. I haven’t even had to call support on any other machine. 😠