u/Ncogknee2

Have UI One 8.5 on my phone. Just went to check my hearing test equalizer settings and they're not there. Additionally, the hearing test keeps cutting me off claiming there's too much noise in the room. I disagree, appears like what's normally here. I Googled the problem and was told to clean my ears (Actually it said to check all microphone ports). I find no contamination on the phone. I also tried to shut off all mics but, I struck out at that because I couldn't keep up with the Google instructions. So, anyone else with this problem?

Let's start by saying that I subscribe to Spectrum. Recently upgraded to 1Gb service. As the service is overprovisioned, I decided to set up link aggregation (ethernet port bonding) to see if I could push my speed over 1GB. First test of, I got 1.15 Gb. (thrilled). However, after that, things went bad and in the month I've had it set up, I've only topped 1Gb once. Additionally, I've got this weird Google G spinning when I open Chrome as if something is wrong. Call Spectrum and the $2 an hour employee says everything is fine and its your fault. Maybe it is. I would add that speeds can be as low as 750 MB but, generally 850 which is worse that what I saw with a single line. Please advise.

I just ordered a 16 pc set of "Spring Blossom Green" from Targets. If I had done better research I would have noticed that I was probably buying a discontinued pattern. I bought the deep green crisp flower pattern versus the newer, light green faded flowers. Subsequent to, I start searching for salad plates and they're not available. So the question is, will Corelle get around to producing this pattern again? I've seen Portofino out of stock but, now its back.

Bought a Hapstone R2 six months ago after buying seven kitchen knives off Amazon ( all Chinese claiming to be powdered steel). I've sharpened them along with a soft steel Bear Grylls hunting knife and two new folding knives (one being Magnacut). None of these knives had anything other than a factory sharpening. Have to be honest. I did not do a thorough inspection under magnification before I sharpened them. But while sharpening, I'm noticing small chips (the Magnacut blade only had 2). Therefore the question is, is my technique causing this or do knives come from the factory with chips? I defer to your expertise and experience.