Brand new x450 Error 1512
So I got in my new x450 this past week. I was on a work trip and didn't get to setting it up until yesterday.
Got everything setup, ran through the installation guide and such. I was away for a while so needed to cut the grass down, did that of course.
Plotted a small map in my yard to run as a test and everything seemed fine, no issues reported. It did the small area and went back to it's charging dock and reported done.
Worked out a schedule, and it tried starting that schedule this morning. It made what looks like 2 loops around the yard and got stuck on the 3rd. Error 1512 Mower motor error.
I figured maybe something got caught in the mower somewhere, expected it to be dirty. There was almost nothing under the deck. Minimal grass really, didn't look bad. Like It said it's got less than a half hour on it at this point.
Put it in cleaning mode, cleaned the deck anyway, found nothing to indicate an issue, nothing blocking the blades, or preventing the blade disks from spinning. Everything spins free, nothing binding, nothing holding up the deck from moving up or down.
Tried again by just going into controller mode? and as soon as I click the button to activate the blades, it hits the error.
I'm kind of guessing here but it almost seems like a motor failure or maybe a motor controller failure. So maybe not a physical issue but maybe a check of the motor is indicating an issue of some sort?
Was hopeful someone might have some insight since it sounds like I'll be in for the long road of waiting for a response on service and maybe waiting for a replacement one? Very disappointed at this point.