u/No-Setting-3201

Hi there, this is the FRSKY EMAX tinyhawk III. Originally the regulator on my flight controller got fried so I had to replace the flight controller and the vtx. Once I replaced those I tried turning it on (first image) and I concluded that since the text was displaying the vtx was fine and the old camera was fried. So I replaced the camera (second image) and I’m getting the same issue. The camera is warming up so I know it’s getting power from the solder and the splice

Got an emax tinyhawk III and fried the 5V regulator, this lead to emax reluctantly sending me a new flight controller and vtx. I kept the camera the same. After the replacement I notice when I click auto on my goggles, the screen eventually picks up the battery voltage and such and displays this, but the footage is black with static, then when I move the drone an arms length away it's fully static. I used to only see static after about 3 meters.

Also the controller isn’t auto binding or even binding when I put the controller in binding mode, however I think that’s just the drone itself not being in binding mode. I’ll confirm that later.

I got sent a replacement flight controller for this drone and I don't know enough to not damage this while re-soldering. Does anyone know a company willing to do this sort of thing? Everyone I phone seems to not deal with this specifically even though I just want a quick soldering job. Willing to drive down to CPT too. Also preferably not requiring me to overpay.